PCIexpress x1 (r 1.0 a) specification

Plug and Play interface

Non-intelligent and low cost CAN controller

Up to 4 CAN 2.0 b interfaces with
SJA1000 CAN controllers

11 bit ID and 29 bit ID CAN
specifications supported

9-pin D-SUB connector for each CAN
interface at PCI bracket

On-board line termination 120 Ω;
enabled by jumper or software

ISO/DIS 11898-2

2 x diagnostic LEDs (green/red) per channel
(only CAN channel 1 and 2)

Additionally an extension module enables the
user to add two more CAN ports to the PCIeL
(additional PCI bracket is needed to connect
the two D-SUB)

Power requirements
   3.3 V (±5 %), max. 450 mA
    12 V (±5 %), max. 150 mA (2 channel)
    12 V (±5 %), max. 300 mA (4 channel)

Operating temperature range 0…70 °C

Non-operating temperature range
-40 °C…85 °C

Humidity 0…80 %, non-condensing

Dimensions (w x d) 131 x 87 mm

Weight approx. 100 g

Isolated CAN, 500 V isolation barrier

Windows, Windows CE, Linux, QNX, VxWorks

Contact your Janz Tec sales offices
for more information

Ordering Information CAN-PCIeL:

BO-FPC-32001: CAN-PCIeL/1; CAN-PCIeL with one SJA1000 CAN controller

BO-FPC-32002: CAN-PCIeL/1O; CAN-PCIeL with one SJA1000 CAN controller, isolated

BO-FPC-32021: CAN-PCIeL/2; CAN-PCIeL with one SJA1000 CAN controller

BO-FPC-32022: CAN-PCIeL/2O; CAN-PCIeL with two SJA1000 CAN controllers, isolated

BO-FPC-32122: CAN-PCIeL/2O/NV/EX; CAN-PCIeL with nvSRAM and expansion connector

BO-FPC-22040: CAN-PCIx/EXTO; Extension module for CAN-PCIeL to support two additional
isolated CAN controllers (same as for  CAN-PCIH)

CB-SOF-32060: CANopen/ID; ICANOS Daemon Run Time licence for Low Cost CAN interfaces

Software Development Kit